Cutie de viteza S40 1998

[Guest eugen]

Am S40 din 1998 si ma intreb ce sa fac sa intre usor in viteza intai si in marsarier ?  Am citit pe net urmatoarele:

This affects:

S80 models 1999 on

S40/V40 models 1998 on

Some of these cars require greater force to select 1st or reverse gear. If 1st or reverse gear is stiff, but the other gears operate normally or are less stiff, the clutch is slipping. This is caused by excessive friction between the input shaft and the clutch hub. A new procedure of cleaning and lubricating the gearbox input shaft is now used by Volvo.

If your car has this problem then contact a Volvo dealership.

  1. Remove the gearbox.

  2. Place a sheet of paper with a small hole in it over the input shaft to protect the concentric slave cylider. This MUST be done as the cleaning oil can damage the seal in the throwout bearing.

  3. Spray cleaning oil, part number 1161398 on the splines and brush with a brass wire brush, then wipe clean.

  4. Repeat above process.

  5. Spray lubricant, part number 1161614 on to the input shaft. Spray from side to side whilst turning the shaft. Wipe off any excess

  6. Reinstall gearbox.

Mai are cineva problema asta ? A facut cineva procedura de mai sus ?

Un mecanic mi-a zis ca e cutie de Renault si ca uleiul din cutie e ok.

Toate bune!

[Danm 0]

La mine si la Relu75 intra greu in marsarier. Tocmai am comandat o bucsa de la Alex si sper sa se rezolve problema. http://www.volvo-club.ro/forum/index.php/topic,1609.0.html

[Guest eugen]

La mine nu cred sa fie asta - intra de fiecare data - insa chiar trebuie sa stii locul la 1-a si sa bagi maxim la stanga si repede si cu ceva forta. Marsarierul la fel trebuie sa apesi pe el cu ceva forta. Cteaodata mai agata si in a doua.

Eu m-am obisnuit cu ea - insa ma gandesc daca o vand cum o sa explic cumparatorului ....

Aveti idee ce pot face ? E ceva logica in citatul din engleza ? - nu ma prea pricep